RW - Deformer: Control Points

You can choose as many control points as desired from the RealWave mesh. Each of these points will then perform an up-and-down movement and disturb the surface.

Active

With “No” the deformer can be disabled temporarily.

Weight

To reduce the influence of a deformer, decrease its weight. Valid settings are between 0.0 (inactive) and 1.0 (full influence).

Frequency

This parameter controls the number of up and down movements of the selected control points. Higher values produce more waves with less distance in-between.

Amplitude

Here the maximum height of the control points is given in metres.

Begin time

Define the time in seconds when the points should start oscillating,

Cycles

This is the amount of up and down movements. The total number of movements (n) is calculated as n = Cycles • Frequency

Wave speed

The waves will have some initial speed once they are created. The value is given in metres per second.

Damping

Higher values reduce the life-span of the waves until they finally disappear.

EDIT CP

When you click on this button an orange frame appears around the viewport and you can select the control points. With a pressed Shift key more points are added to your current choice.

CLEAR CP

If you are not happy with your current selection or do not need it anymore use this button.