Wet

Starting point for wet particles is always an existing → core fluid simulation.

Scene Setup

• Set the domain's simulation state to → “Cache” (“yellow rocket”).

• Other, already simulated Hybrido secondary fluids emitters have be set to “Cache” as well.

• Add a “Wet” emitter from the “Hybrido” shelf.

• Reset the scene.

What you see now is a cross in the viewport's centre, indicating that the emitter is not bounded. You can prevent the particles from leaving the domain:

• Add/reuse a → “k Volume” daemon and adjust it to the scene with the R key.

• Or make sure that the particles will be enclosed inside a container or a cube.

Open the emitter's → “Wet Creation” panel:

• Choose the object(s) which should create the wet particles.

• Adjust the “Object offset”. This is the distance between the objects and the wet particles in metres.

• Be careful with “Emission rate”, because the temporary amount of particles can become very large.

• Particles below the core fluid's surface are deleted.

Simulate.