Waterline - Waterline Dynamics
- thomas (Unlicensed)
Here is the place to control the waterline particles' lifetime and behaviour.
Surface offset
With 0.0, particles are created directly at the fluid's surface, but you can also define an offset between the core fluid and the splashes. This distance is measured in metres.
Stringiness
If you can see filaments and regular foam patterns please decrease this parameter. “Stringiness” ranges ranges between 0.0 and 1.0; 0.0 can help to suppress the filament effect.
Min lifetime
If you want to destroy the particles after a certain time then you can define a lifespan with “Min | Max lifetime". The actual lifetime will be somewhere between both values, and this value defines the lower limit. The value is given seconds.
Max lifetime
If you want to destroy the particles after a certain time then you can define a lifespan with “Min | Max lifetime”. The actual lifetime will be somewhere between both values, and this value defines the upper limit. The value is given seconds.
Min friction
This value specifies the minimum amount of the grid fluid’s velocity that will be transferred to the waterline particle. 1.0 means that the entire velocity is transferred and the waterline particles are stuck to the grid fluid. With 0.0 the waterline particles are not affected. If you use different values for the min and max parameters the actual friction will be somewhere between both settings.
Max friction
This value specifies the maximum amount of the grid fluid’s velocity that will be transferred to the waterline particle. 1.0 means that the entire velocity is transferred and the waterline particles are stuck to the grid fluid. With 0.0 the waterline particles are not affected. If you use different values for the min and max parameters the actual friction will be somewhere between both settings.