Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Next »

One common question is how to stop the emission of new particles? There are several methods to do this.

HyFLIP

Defining a Volume

The relevant settings are located in the Hybrido emitter node under HY_Emitter node > Node Params > Emitter:

  • When “Stream” is set to “No” RealFlow creates a certain number of particles based on the shape of the object under Node Params > Emitter > Object. Once the simulation starts no more particles will be created. This mode is comparable to the  “Volume” option of the → Dyverso and → standard particle emitters.

 

Stream Animation

In simulations where “Stream” is set to “Yes” it is possible to animate the parameter:

 

 

  • Let's say the emission of particles should stop at frame 50.
  • Stream > Yes
  • Shift the timeline slider to frame 49.
  • Click on the dot next to the “Stream” parameter.
  • Go to frame 50, set “Stream” to “No”, and click again on the dot.
  • Right-click on “Stream” and choose “Open curve”. The “Curve Editor” is opened.
  • Select the two keys and click on “Set Selected Points Type to Stepped” (see image below).

 

 

Stream Expression

A very simple, yet effective method is to manage emission with an expression:

  • Right-click on “Stream” and choose “Open curve”. The “Curve Editor” is opened.
  • In the empty field to the left of "Delete Expression" enter: if(f>49,0,1)
  • This expression says that if the current frame is greater than 49 the “Stream” option will be set from “Yes” to “No”.
  • These two states are represented as binary numbers here – 1 and 0.



Standard Emitters

Emitter Volume

Similar to HyFLIP emitters, SPH-PBF some emitters let you define a certain volume that is filled with particles:

  • Emitter node > Node Params > emitter-specific section (e.g. “Circle”) > Volume
  • “Sphere” and “Fill Object” have a built-in fill option.

 

 

Speed – Animation and Expressions

The next two methods are exactly the same as described under “HyFLIP” and use animation keys and an expression. The only difference is that with SPH standard particle emitters the “Speed” parameter is animated and set to 0:

  • Emitter node > Node Params > emitter-specific section (e.g. “Circle”) > Speed

 

If you work with an expression, the two arguments are 0.0 and the emitter's current speed. By default, this is 2.0:

  • Right-click on “Stream” and choose “Open curve”. The “Curve Editor” is opened.
  • In the empty field to the left of "Delete Expression" enter: if(f>49,0.0,2.0)
  • This expression says that if the current frame is greater than 49 the “Speed” parameter will be set from 2.0 to 0.0.

 

 

Particle Limit

Another idea is to define a particle limit with

  • Emitter node > Node Params > Particles > Max Particles
  • Just enter a number, e.g. 75000, and the emitter will stop to create new particles once this limit has been reached. Please bear in mind that you will normally get a few more particles.



Dyverso Emitters

With these fluid emitters you have exactly the same possibilities as with "Standard Emitters" – only the "Particle Limit" is not supported.

  • No labels