Displacement, also known as ocean statistical spectrum, is a layer of small waves and ripples that is added to a → HyFLIP fluid surface to enhance realism. The displacement itself is invisible and can only be seen in conjunction with a mesh.
- Create a → basic HyFLIP scene, for example with the “Open Domain” tool.
- Add some turbulence by moving an → animated object through the fluid.
The Base Mesh
Before we proceed, it is important to set the domain to → “cache”:
- Click on the domain node's small green rocket.
- The yellow colour indicates the cache mode.
- Move the domain's viewport icon (plane with four boxes) to the upper third of the fluid.
Add a mesh – all settings are made under “Node Params”:
- Mesh shelf > Hybrido mesh VDB
- Boundaries > Open Boundaries > Yes
- The last action will remove all polygons outside and below the domain's viewport plane.
- Displacement > Use displacement > Yes
The Ocean Statistical Spectrum
Open the domain node's → “Ocean Statistical Spectrum”. There you will see a long parameter list, but just a few a really relevant for your daily work. The result can only be seen when you create a mesh:
Calculate displacement
Set this option to “Always”:
- RealFlow will calculate a displacement map immediately using the default values.
- Whenever you change a value, the displacement is recalculated for the current frame.
Vertical scale
This parameter mainly depends on “@ dimension”, but you should start with the default settings. If the surface is flat increase the value.
@ dimension
If the level of detail is low, disable “Auto dimension”m and increase this parameter. A good start is a value is around 2 – 3x the size of the domain's viewport plane (10 m by default).
@ wind speed
This parameter removes spiky patterns, smoothes the surfaces, and creates the typical wavy look. A value between 20 and 30 m/s works best.
Seed
Enter any positive integer to change the waves' initial distribution.
Choppiness
Create sharp wave crests; start with values between 0.8 and 1.2.
The Displacement Mesh
Go to a frame with enough detail, splashy structures, and turbulence. The select the mesh and click on
- Mesh shelf > Build mesh to create a single mesh from the current frame.
A possible result could look like in this image:
In order to proceed and refine your settings, change the HyFLIP domain's “Ocean Statistical Spectrum” parameters and create test meshes until you are satisfied. Please also consider the “Displacement” section's attenuation options, to remove the spectrum waves from splashy structures or areas with high vorticity.
The Mesh Range
In the final step, the entire simulation range is meshed. Currently, the displacement has been create for a single frame:
- Reset the scene and simulate.
- The domain's “cache” mode prevents the fluid from being re-simulated – only the displacement is calculated.
- The mesh is created simultaneously.