...
- The most relevant parameters are “MIN | MAX sub steps” and “MAX iterations”.
- Settings under “Liquid – Hybrido” only affect the core fluid. The default “MAX sub steps” value of 2 is sufficient in most cases. If the fluid moves very fast increase this value.
- “MIN | MAX sub steps” under “Liquid – Particles Solver” should only be changed if the simulation of "Liquid" Hybrido secondary fluids is very slow, or if you observe stability problems.
- “MAX iterations” can be left untouched in most case. If the default values are not sufficient you will get a warning in the → “Messages” window.
- “Use OpenCL-GPU” is only relevant with core fluid simulationsfluid (= Hybrido domain without splashes, foam, etc.) simulations. The typical speed boost is as if there is one additional CPU/core. If the checkbox is greyed out your graphic board cannot be used.
...