A Hybrido setup is a matter of just a few clicks. The basic scene we create here will be the starting point for various workflow simulations with → Hybrido's secondary fluids (splash, foam, etc.).
Environment
| Note |
|---|
| All settings, described here and under "The Hybrido Fluid Setup", are located under the different nodes' → “Node Params” panels. |
...
This is the basic environment where the fluid simulation is going to take place. The container acts like a pool, the “Emission object” node defines the water volume. The → “k Volume” daemon will remove escaping particles.
Hybrido Domain Setup
Go to the “Hybrido” shelf and add the following nodes:
...
- Grid > Cell size > 0.1
- Creation mode > Dense will speed up the simulation.
- Particle Sampling > disable all “control” options, because we want to keep the number of particles constant throughout the simulation.
Hybrido Emitter Setup
Let's proceed with the “HY_Emitter01” node:
...