RW - RWC Sequence Deformer

Owned by thomas (Unlicensed)
Last updated: 11 Aug, 2016
1 min read

To add this wave deformer, right-click on the "Realwave01" entry in the "Nodes" panel and choose Add Wave > RWC Sequence.

"RWC Sequence" loads a previously simulated sequence of RWC files from the disk and applies it to a RealWave surface.



 

Active

With “No” the deformer can be disabled temporarily.

Weight

To reduce the influence of a deformer, decrease its weight. Valid settings are between 0.0 (inactive) and 1.0 (full influence).

RWC Sequence

Here, the RWC file sequence is loaded.

Mode

You can choose from three different modes:

  • “Normal” plays back the sequence from the first to the last frame.
  • “Loop” jumps back to the very first frame after the end has been reached.
  • “PingPong” plays the sequence back and forth.
Reverse

Enable this option to start with the last frame for playback.

Number of frames

This field tells you how many RWC files were found and applied to the RealWave mesh.

Frame Offset

Specify a new start frame for playback.