Mist

Starting point for splashes is always an existing → core fluid and → splash and/or → wet simulation.

Scene Setup

• Set the domain's and splash emitter's simulation state to → “Cache” (“yellow rocket”).
• Other, already simulated Hybrido secondary fluids emitters have be set to “Cache” as well.
• Add a “Mist” node from the “Hybrido” shelf.
• Reset the scene.

What you can see now is a bounding box with a dimension of 10 m x 10 m x 10 m. The box can be positioned and scaled with the settings under Node Params > Node or the W and R keys. Mist is

• only created inside this box and it cannot leave its domain
• not affected by “k” daemons.

Open the → “Mist” parameter section for further adjustments:

• “Cell size” can be set independently from the domain's own → “Cell size” value.
• “Solver” should be “Fast” – the results will be good enough.
• “Radius threshold” is the most important parameter, because it controls the amount of foam (see below for more information).

The "Radius threshold" parameter depends on the splash particles' lifetime.

• When a splash particle is created its radius is 1. Depending on the lifetime settings, the particle's radius becomes smaller over time until it reaches 0.
• Lifetime is adjusted under → "Splash Dynamics" or → "Wet Dynamics".
• You have to decrease these parameters in most cases, e.g. to 1.5 s ("Splash | Wet min lifetime") and 2.0 s ("Splash | Wet max lifetime").
• Smaller thresholds will reduce the amount of mist.

Simulate.