Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 7 Next »

RealFlow | Cinema 4D is able to simulate interactions between different fluids to achieve effects like the separation of water and oil, or sand being washed away by water.

The scene setup follows exactly the same rules as with a single fluid:

  • Create two or more fluid containers and emitters and adjust them.
  • Add daemons and objects on demand.

 

A typical setup for a water-and-oil simulation.

The most important part is to check the links between the scene objects:

  • If you want a daemon act on all fluids put the fluids to the "Links" fields.
  • The same applies to the "Collider" tags: fluids will only interact with linked objects/tags.

 

Both fluid containers have to be linked to the "Gravity" daemon and the "Collider" tag.

 

  • In order to make the fluids interact with each other they have to be linked as well: Fluid_Water => Fluid_Oil and Fluid_Oil => Fluid_Water

  • The emitters have to be linked to their appropriate fluid containers: Fluid_Water => Emitter_Water and Fluid_Oil => Emitter_Oil

Density & Surface Tension

The fluids' "Density" parameters are the key to oil-water separation or foamy materials:

  • The fluid with the lower "Density" value will float on top, the one with the higher density will sink.
  • If both fluids have the same "Density" values they will mix, not separate.
  • Search the internet for density values for different materials.
  • Sometimes it is necessary to use a rather big difference between densities, e.g. 400 and 1000, in order to see a separating effect.

"Surface Tension" can be used to create bubble-like structures or drops, and create a better, more realistic impression, and slightly higher "Viscosity" for the oil is also helpful.

 

The settings for "Fluid_Oil" with low "Density" and increased "Viscosity". "Surface tension" creates drops.

Problems

With pure "Liquid - PBD" fluids it might happen that the simulation does not meet your expectations, e.g. esp. with water and foam or oil in water. We therefore recommend using the "Liquid - SPH" type for these kinds of simulations.

The simulation will take longer, but with much better results.

 

Result from the scene above. Water mixes with oil and creates drops during the separation process.
  • No labels