...
This parameter is only available when “Break if distance is exceeded” is set to “Yes”. It defines the distance at which a MultiServo breaks and becomes inactive. “@ Break distance” is measured in meters [m].
Break if angle exceeded
The mode of operation is exactly the same as with “Break if distance exceeded”, but here the decisive criteria is the angle between the target and the reference object.
...
When “Break if angle exceeded” is set to “Yes”, this parameter is active and you can specify the desired angle to break the MultiServo connection. This value is given in degrees [deg].
Remember that you can also control when a MultiServo should or should not act by animating the "Simulation" field of the "Node Panel".
...