Page Comparison

...

• The more particles, the better the mesh.

It is very can be difficult to get a good mesh from just a few hundreds or thousands of particles. Those meshes normally often look blobby and muddy, and not like water.:

Image Added

Meshes with default settings created from simulations with 5000 and 92000 particles

Resolution, Radius, Smooth

...

• "Resolution" determines the mesh's level of quality, and better settings will create more and but smaller polygons.
• "Radius" is the size of the spheres RealFlow | Cinema 4D creates around the particles to blend them together. With high values meshes often look thick and blobby, low values create a torn look.

So, the art is to find a balance between "Resolution" and "Radius". Since this balance is sometimes difficult to get achieve you should take a look at "Smooth":

• "Smooth" controls how strong the individual spheres will be blended together. 
• A starting value around 3 4 or 4 5 is good. Higher values will remove more detail from the mesh.

Image Added

The mesh from above with higher "Resolution" and smoothing.

Thinning, Relax

Another very common mistake is the extensive use of the "Thinning" and "Relax" filters:

• These parameters are applied to sharpen a mesh's border, but very high settings may create the look of liquid metal.
• Start with moderate "Relax" values, e.g. 0.1, and increase the number of "Relax Iterations" instead (e.g. 5) to get better control.
• "Thinning" will shrink the mesh and when the value is too high the mesh will not match the underlying particle cloud anymore.

Image Added

The same mesh shows more details with "Thinning" and "Relax".

Building the Mesh

At the moment, particle simulation and meshing are connected: when the mesh sequence is being cached, the particle simulation will always be performed as well .(please note that it is currently not possible to create meshes from already cached simulations). Individual meshes for testing purposes can be created though:

Image Added

• "Auto Build". When enabled the mesh will be created automatically when you change a parameter from the "Mesh" tab.
• "Build" Mesh". A click on this button triggers the mesh creation process.

...