With the help of this panel it is possible to configure a command line simulation. The parameters do not have any effect on GUI simulations.
IMAGE
...
Range
...
Same as scene
When this option is checked the command line simulation's range is exactly the same as the one adjusted on the timeline. To specify a new range, disable “Same as scene” and enter your values in the unlocked fields below.
...
If you want to perform a simulation within a specified range only, uncheck “Same as scene” and enter start and stop frames. Please make sure that “Frame begin” is smaller than “Frame end” to get a plausible result. “Frame begin” also needs to be adjusted if you want to resume a simulation from a certain point in time.
...
Threads
...
Same as scene
This option is enabled by default and the number of threads is read from the scene's “Simulation options”. In some cases, for example with very low particle counts, it is often helpful to use only one or two threads to accelerate the simulation. If you disable the checkbox the “Threads” field becomes editable.
Threads
To enter a new number of threads you have to disable “Same as scene” first. Then, you can enter a new value.
...
Args
...
None
With this option enabled, RealFlow will perform a “normal” simulation using the current scene's settings; the simulation performs exactly the same way as if you were executing it inside the GUI version – but faster.
...