Here you can adjust the particles' lifespan.
Surface offset
With 0.0, particles are created directly at the fluid's surface, but you can also define an offset between the core fluid and the splashes. This distance is measured in metres.
...
If you want to destroy the particles after a certain time then you can define a lifespan with “Splash min | max lifetime”. The actual lifetime will be somewhere between both values, and this value defines the lower limit. The value is , given in seconds:
- This parameter is of particular importance if you want to create foam or mist from splashes, because it controls the particles' radius values.
- In order to make use of the → "Foam" emitter's and → "Mist" node's "Particle radius" parameters you have to decrease the splash particles' lifetime.
Splash max lifetime
If you want to destroy the particles after a certain time then you can define a lifespan with “Splash min | max lifetime”. The actual lifetime will be somewhere between both values, and this value defines the upper limit. The value is , given in seconds:
- This parameter is of particular importance if you want to create foam or mist from splashes, because it controls the particles' radius values.
- In order to make use of the → "Foam" emitter's and → "Mist" node's "Particle radius" parameters you have to decrease the splash particles' lifetime.
Foam strength
Splash particles have the ability to contribute to foam maps. With higher settings you will achieve a stronger effect. To activate