A Hybrido setup is a matter of just a few clicks. The basic scene we create here will be the starting point for various workflow descriptions, where you will learn how to use the → HySPH secondary particle emitters (splash, foam, etc.).
The Environment
| Note |
|---|
| All settings, described here and under "The Hybrido Fluid Setup", are located under the different nodes' → “Node Params” panels. |
...
This is the basic environment where the fluid simulation is going to take place. The container acts like a pool, the “Emission object” node defines the water volume. The → “k Volume” daemon will remove escaping particles.
The Hybrido Fluid Setup
Go to the “Hybrido” shelf and add the following nodes:
...